Meet Dan Gray
Owner of
|
|
|
|
686 Main Road
|
|
|
Click Here For D.G. Gray & Sons |
Click Here For Gray Knives' Virtual Catalog |
|
Below are 7 Step By Step photos , In making My M#117-3 Knife
wood, steel, pins, Brass, ecct.
mark & cut out the steel, and pick out your handle materials
grind out the blade & heat treat
fit finger gaurd, pin & weld
fit wood with gaurd & butt end, clamp & weld butt parts and pin. do a little shaping
now opoxy wood in place.
shape and finish put on the logo and it's done
For More Infomation On This Knife Click On It and see The M# 117-3
With this M#117-4, you'll see where the Micarta meets the bolster
is tapered, to insure it can't come out of place.
times since Jan 7, 1999.
This page was last updated
This site was created by
Webitup
Copyright © 1998,1999, All Rights Reserved
wood, steel, pins, Brass, ecct.
mark & cut out the steel, and pick out your handle materials
grind out the blade & heat treat
fit finger gaurd, pin & weld
fit wood with gaurd & butt end, clamp & weld butt parts and pin. do a little shaping
now opoxy wood in place.
For More Infomation On This Knife Click On It and see The M# 117-3
With this M#117-4, you'll see where the Micarta meets the bolster
is tapered, to insure it can't come out of place.
times since Jan 7, 1999.
This page was last updated
This site was created by
Webitup
Copyright © 1998,1999, All Rights Reserved
grind out the blade & heat treat
fit finger gaurd, pin & weld
fit wood with gaurd & butt end, clamp & weld butt parts and pin. do a little shaping
now opoxy wood in place.
For More Infomation On This Knife Click On It and see The M# 117-3
With this M#117-4, you'll see where the Micarta meets the bolster
is tapered, to insure it can't come out of place.
times since Jan 7, 1999.
This page was last updated
This site was created by
Webitup
Copyright © 1998,1999, All Rights Reserved
fit wood with gaurd & butt end, clamp & weld butt parts and pin. do a little shaping
now opoxy wood in place.
For More Infomation On This Knife Click On It and see The M# 117-3
With this M#117-4, you'll see where the Micarta meets the bolster
is tapered, to insure it can't come out of place.
times since Jan 7, 1999.
This page was last updated
This site was created by
Webitup
Copyright © 1998,1999, All Rights Reserved
shape and finish put on the logo and it's doneFor More Infomation On This Knife Click On It and see The M# 117-3
With this M#117-4, you'll see where the Micarta meets the bolster
is tapered, to insure it can't come out of place.
This page was last updated
This site was created by
WebitupCopyright © 1998,1999, All Rights Reserved